Still Supporting Hydreco Equipment
If your machine runs a legacy Hydreco pump, motor, or valve and the usual channels have dried up, there is a good chance we can help.
Repair first. Most legacy Hydreco failures do not need a replacement unit — they need a factory rebuild by the shop that used to build them. Reidville Hydraulics has previously been the licensed manufacturer for several Hydreco legacy products, and we maintain a large inventory of parts — including seals and wipers — to support factory rebuilds of covered models.
Coverage depends on the specific unit. The fastest path is to contact us with the model number stamped on your pump, motor, or valve, along with a short description of the failure. We will confirm whether a factory rebuild is available and quote it.
Have the model number ready when you call: (860) 496-1133.
Factory Rebuilds
Rebuilds of covered legacy Hydreco models from our own parts inventory — seals, wipers, and hard parts — with in-house testing on every unit before it leaves the shop.
Tested Before Delivery
Every repair is tested in house on our bench, up to 100 GPM and 5,000 PSI, with results documented.
When Rebuild Is Not Enough
As a full hydraulic manufacturer, in some cases of catastrophic failure it is more cost effective for us to manufacture a new unit, usually quicker than an OEM replacement.
One Roof
Machining, assembly, testing, and a walk-in service counter at the same Torrington facility. No shipping your unit across the country and hoping.
Or Write to Us
Send the model number and failure description through the contact form and we will get back to you with rebuild availability.